Tuesday, February 17, 2009

Workshop Beginnings in SketchUp

This is my first attempt to draw 3D with SketchUp. It is not complete nor accurate at this point. I need to add rafters, extend the beams for barge rafters, and adjust my dimensions. I want when completed a shop around 16'x32'. Being a hillbilly, I have no choice but dirt floor (concrete is roughly $100yd here now). I will either set the post on poured concrete piers or flat out sink them in the ground. The walls will be wrapped in board and batten siding from the 1x's I have been pulling while milling posts.


No comments:

Post a Comment